DRAWING CHECK
Are the following aspect correct:
1. INPUT DATA
a. Conformance with Isometrics
-Pipe Diameter
-Piping Class ( including Class breaks )
-Dimensions
-Support Locations
-Rigid Weights
-Major connecting lines considered
b. Conformance with Line List
-Line Number
-Piping Class and Material of Construction
-Design Temperature
-Design Pressure
-Test medium / pressure
c. Conformance with Piping Class
-Material
-Thickness
-Corrosion Allowance
-Allowable Stress
-Applicable Codes
d. Environmental Data
-Wind Data
-Seismic Data
e. Dynamic Loading Data
2. OUTPUT DATA
-Restraint Loads: Within acceptable limits (as accepted by Civil/Structural )
-Displacements: Within allowable limits
-Stresses: Within allowable limits
-Nozzle Loads: Within allowable limits
-All Load cases considered
-Spring hanger / Spring selection
-Applicable Vendor Catalogue information
-Confirmation of Supports / Restraint location and type ( feasibility ) from Design Group
